hi
i am suraj
i am working in a project where i want to send a signal or the input through the gui and the output should be in the gpio pin the board
i have referred the corresponding link for an example forma of functioning it but i am stucked with a question that where is the port pin selection is been done as example for the port 3 and pin 21 selection the corresponding pin with port will be initialized and so i couldnt able to find it here
there is the place it has been given as to be port write high or low
i have attached the page which i referred for further reference
in device integration, i found that the device class should be the application class for the gui and the pin value is been told to initialize or told to give the state but i have a doubt that without knowing the device gpio port and the pin how can i give the value to be high or low.
https://doc.embedded-wizard.de/device-class-command?v=10.00
do help me as soon as possible
with regards
suraj